Focus position of the vehicle which sealed

Focus position of the vehicle sealing the following areas:

First, the vehicle doors and windows sealed

Before installing the glass doors of the vehicle to clear the debris carefully notch within such as mortar, brick dust, wood, etc., should be placed carefully on the glass, ensuring that both sides of the gap is uniform and timely than the positive fixed to prevent collisions shift deviate from the slot center. Rubber seal can not pull too tight, cutting length longer than the assembly length 20-30mm. When installing the mosaic in place, flat surfaces, and glass notch in close contact, so that the glass surrounding the force evenly. In the corner of the rubber should be beveled off and disconnect the injection of glue at the firm. When caulk sealant fixed glass, you should use rubber or rubber block glass and choked, leaving voids plastic injection, plastic injection depth should not be less than 5mm, before the glue curing, the glass should be kept free from vibration.

Second, the leading edge of the vehicle seal, the seal along the side edges and

Support from the hood, on the bonnet leading edge, a trailing edge and side edges of the body of the anastomotic site and paste, can the gap between the hood and the body effectively sealed vehicles on the way, can accelerate the air from the intake gate through the improved thermal performance. At the same time, you can reduce the hood and the front part, the friction between the left and right front fender, reducing noise and friction caused by the bump. If the gap is large, you can paste layers.

Three, four slits seal between the door and the vehicle body

Four of the gap seal between the door and the vehicle body, the vehicle can improve the sealing performance, reducing wind noise. Improve sealing performance can also prevent dust, rainwater into the cockpit to improve the efficiency of air conditioning and refrigeration. Carefully coated with special glue on the inside of the door, will cut a good seal side also coated with special glue, then along the inside of the door ring seal affixed.

Fourth, skylights and other components inside sealed

On the roof around the paste, can effectively improve the seal, dustproof and waterproof; wrapped pipes for air conditioning and refrigeration, can improve the cooling efficiency.tamper seal tape Between the door trim panels and the gap between the dashboard, storage boxes and other interior parts of the car, because the assembly and machining accuracy and other reasons, there is often friction, vehicle process will cause resonance at different speeds generate disturbing noise, which is generally very difficult to find. In fact, know the reason, as long as the seal to fill these gaps, paste.

Fifth, there is the door seal sealing flange

When the door flange seal repair, the repair should be noted that damage to the sealing flange, the flange accurately recover the original shape. After repairing the door seal to conduct inspection, inspection methods are: put a piece of cardboard in a sealed position, close the door, and then pull the paper, according to the Rally to determine the size of the seal is good. If the force required to pull the paper too much explanation sealed tight, it will affect the normal shut the door, and also due to deformation of the seal over the Omo rapid loss of sealing performance; If the force required to pull the paper through the small, indicating that the door seal seal bad, the wind will always be a door without rain phenomenon. metal security seal When replacing the door must pay attention to the inner and outer door panels in the new bite at the painted folding plastic cuffs and put some holes left when punching with the base tape blocked.

Do the above seal, your car will be able to rain or shine, for you to make the power of pleasures efficiency! In the rainy season will not shed tears for no reason!