In the application of the gas mixer seals

On the mixer using a gas seal for the user has three main advantages:
No liquid leakage; no effect on product quality; little effect on the reaction or no effect; such a sealing member also has some other advantages. Include: Operation Clean (GMP); friction loss low; does not happen noise; mechanical wear little or no wear.
If the seal system used in the mixer for the above requirements, then such seal member is operable. The main purpose of the current mixer, what is it (low speed)?
DIN mixer for compliance with requirements in DIN steel container seals; DIN mixer used with DIN-compliant seal enamel containers; used for disinfection purposes mixer; vertical suction filter / drier; special purpose (on the product for horizontal installation). Pressure uses, such a sealing member is usually used in vacuum conditions, up to 6bar.
In the past 10 years, since the wire seals  was first introduced low-speed applications, it has been made a lot of experience. Especially when the user is in the learning phase, has made a number of important insights. Mechanical seals according to the user as part of the liquid lubrication 40 years experience in the use of seals has been made very clear differences and application restrictions should still be recognized and given requirements. Used in the past is not a liquid seal for each product gas seals. The main factor to consider is the product has a high sensitivity (for example, the sealing surface is touched.) To counteract this effect, many types of research and the use of additional components, such as the patented flush mounting flange. When the sealing surface of the automatic alignment feature degradation when converted into their own gas consumption, the sealing surface is blown or is rinse. The mounting flange can be used for washing steel container, especially for the enamel container (plastic container). Apart from the gas seal applications beyond the experience gained in the storage and use has also made a series of new insights. When the plastic seals member to achieve its first time of change, and start using the ship between the seal member, may be after many years. Same time, various factors can influence the characteristics of the gas seal member. In the assembly accidentally add too much grease or oil - grease or oil into or penetrate into the sealing gap. Then, in use, a clearance resulting imbalance seal damage. Based on its past experience, the seals at its beginning before use, it should be checked. If the storage period is too long, the aging effect can also occur on synthetic rubber.